Steam broadcast video checker
Updated 11 Nov 2026 · free, runs in your browser
Pick a video file and this tool reads its settings straight from the file, in your browser, and compares them with the RTMP spec in Valve's broadcast documentation. Nothing is uploaded anywhere. It is useful before you loop a prerecorded trailer or gameplay video on your store page, and when a broadcast stutters or will not start.
MKV, WebM or another format? Paste ffprobe output
Run this and paste the result (needs ffmpeg):
Optional, for the keyframe interval: paste the output of
What the checker compares against
Valve lists these encoding settings under "RTMP Streaming Specs" in its Setting up a broadcast guide. The checker uses exactly these values; nothing is added.
| Setting | Valve requires |
|---|---|
| Video codec | H.264 |
| Profile / level | High / 4.1 |
| Frame rate | 30 or 60 fps |
| Frame ratio | 16:9 |
| Keyframe interval | 2 seconds |
| Video bitrate | 7000 kbps maximum, CBR |
| Audio codec | AAC-LC |
| Audio bitrate | 128 kbps maximum |
Source: Steamworks documentation, store/broadcast/setting_up, read 11 Nov 2026.
When the file settings matter
If you stream the file as it is, for example with ffmpeg -c copy, Steam receives exactly what is in the file, so every row above has to pass. If OBS or another encoder re-encodes the video while streaming, the output settings of that encoder are what Steam sees; then use this check to spot problems like a variable frame rate or the wrong aspect ratio, and set the keyframe interval and bitrate in the encoder.
Valve is direct about the keyframe interval: in its OBS steps it says that without a 2 second keyframe interval "your stream will fail to start". When a broadcast keeps dropping, Valve's broadcast history can show "Make sure your upload key-frame interval is set to 2 seconds and use constant bitrate (CBR)."
Reading the results
Fail means the file breaks a value Valve lists. Check means it differs from the listed value but may still play, such as a 29.97 fps file, a different H.264 level, or bitrate peaks above 7000 kbps in a file whose average is below it. Bitrate is measured from the size of each frame, so "peak" is the busiest one-second stretch of the file.
The checker reads the MP4 index (the moov box), so even large files take a second or two. Fragmented MP4 files keep their frame timing outside the index; for those, use the ffprobe option.
Fixing a file that fails
Our guides Encoding a broadcast video and Steam RTMP streaming guide walk through the encoder settings and a working ffmpeg command. Loopcast handles the broadcast for you: it keeps a prerecorded video live on your store page around the clock.
Made by Loopcast. The checker is free and needs no account.